|
BPOCO
POLYGLAS
USES
POLYGLAS with its
unique combination of properties is ideal for use in heavy duty
applications such as bridge waterproofing, tunnels, tanking..etc. In fact,
anywhere above and below ground where toughness, impact resistance and
dimensional stability are required.
OUTSTANDING
FEATURES
· Dimensional
stability.
· Puncture resistance.
- Robustness.
- Increased resistance to hydraulic pressure.
GENERAL
DATA
DESCRIPTION
POLYGLAS is a
range of modified bitumen membranes which incorporates a special double
reinforcement of non woven, spun bond polyester fabric and a glass
fiber mat. This multi-layer construction is positioned within the mass of
modified APP bitumen coating. The finished product is a general purpose,
high performance waterproofing membrane with added qualities of
dimensional stability and robustness.
STANDARDS
POLYGLAS complies
with the requirements and tolerance levels of :
1. The American Society For Testing & Material, ASTM D-6223
Type I or Type II*.
2.UEAtc (European Union of Technical Agreement).
3.MOAT 27-1983 and MOAT 30-1984.
4.CGSB (Canadian General Standards Board) 37-GP56M-July 1980.
INSTALLATION
TOOLS REQUIRED
Gas torch, Knife,
Trowel, Measuring tape, Marking string, Gloves.
APPLICATION
POLYGLAS is
installed by torch welding method, loose-laid or fully bonded to
substrate. When loose-laid, only laps are bonded together. Peripheries and
protrusions are sealed according to specifications.
INSTALLATION
TOOLS REQUIRED
Gas torch, Knife,
Trowel, Measuring tape, Marking string, Gloves.
APPLICATION
POLYGLAS is
installed by torch welding method, loose-laid or fully bonded to
substrate. When loose-laid, only laps are bonded together. Peripheries and
protrusions are sealed according to specifications.
COVERAGE
RATE
|
For
flat areas
|
1.13
M2/M2 per layer
|
|
For
30 cm. girth flashing
|
0.35
M2/Mt/ length
|
|
Average
wastage
|
3
- 5%
|
TORCHING
GUIDELINE
The underside of
the membrane should be torched just enough to superficially melt the
bitumen. Excessive heating may damage the reinforcement. Overlaps should
be re-heated from the top and resealed with a trowel to ensure seam
integrity.For details of installation methods and flashing requirements,
consult the relevant BITUMAT Design and Installation Manual.
|
Roll
length
|
10
mt.
|
|
Roll
width
|
1
mt.
|
|
Thickness
|
3,
4, 5, mm
|
|
Reinforcement
|
180
gsm nonwoven polyester fabric & 50 gsm of glasfiber matt. Other
weights available on request.
|
*
On request product is available to meet the requirements.
FINISHES
POLYGLAS is
available in two basic finishes:
- Black smooth finish with polyethylene surfaces for covered
pplications.
- Granule surfacing for exposed applications.
QUALITY CONTROL
In addition to stringent regular tests by BITUMAT laboratory, our
products are tested periodically by Bureau Veritas, SOCOTEC, Paris,
France.
TECHNICAL
DATA - POLYGLAS
|
