FINISHES
Available in two basic finishes:
-Black smooth finish with polyethylene
surfaces for covered applications.
-Granule surfacing for exposed applications.
Fine sanded upper surface in 3,4,5, mm are
also available for covered applications.
QUALITY
CONTROL
In
addition to stringent regular tests by BITUMAT
laboratory, our products are tested
periodically by Bureau Veritas, SOCOTEC,
Paris, France.
STANDARDS
POLYFLAME complies with the requirements
and tolerance levels of :
1. The American Societty For Testing
& Material, ASTM D-6222 Type II.
2.UEAtc (European Union of Technical
Agreement).
3.MOAT 27-1983 and MOAT 30-1984.
4.CGSB (Canadian General Standards
Board) 37-GP56M-July 1980.
APPLICATION
POLYFLAME is installed by torch
welding method, loose-laid or fully bonded to
substrate. When loose-laid, only laps are
bonded together. Peripheries and protrusions
are sealed according to specifications.
TORCHING
GUIDELINES
The underside
of the membrane should be torched just enough
to superficially melt the bitumen. Excessive
heating may damage the reinforcement. Overlaps
should be re-heated from the top and resealed
with a trowel to ensure seam integrity. For
details of installation methods and flashing
requirements, consult the relevant Design.
INSTALLATION
TOOLS REQUIRED
a Gas torch,
Knife, Trowel, Measuring tape, Marking string,
Gloves.nd Installation Manual.
